AudioCodes Mediant 2000 Manual de instalación descargar pdf (Pagina 17)

Version 6.0 17 March 2010

Installation Manual 2. Installing the Device

The 50-pin male Telco cable connector must be wired according to the pinouts in the table

below, and to mate with the female connector illustrated in the figure below.

Figure 2-8: 50-pin Female Telco Board-Mounted Connector

Table 2-3: E1/T1 Connector Pinouts for Each 50-pin Telco Connector

E1/T1 Trunk Number Tx Pins (Tip/Ring) Rx Pins (Tip/Ring)

1 to 8 9 to 16

1 9 27/2 26/1

2 10 29/4 28/3

3 11 31/6 30/5

4 12 33/8 32/7

5 13 35/10 34/9

6 14 37/12 36/11

7 15 39/14 38/13

8 16 41/16 40/15

¾ To connect E1/T1 trunks using RJ-48c connectors (1-, 2-, 4-, 8-trunk

device):

1. Connect the E1/T1 trunk cables to the ports labeled PSTN 1 to 8 (in the case of the 8-

trunk device) on the device's rear panel.

2. Connect the other ends of the Trunk cables to the PBX/PSTN switch.

RJ-48c trunk connectors are wired according to the connector pinouts shown in the figure

below:

Figure 2-9: RJ-48c Connector Pinouts

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Sin comentarios

AudioCodes Mediant 2000 Manual de instalación Pagina 17