
Significant .ini parameters continued:
Gateway Host Name. Used in host portion in the
SIP address in the From header.
Example: SipGatewayName = mp1xxfxo.inin.com
DNSPriServerIP
DNSSecServerIP
Address of the primary and secondary DNS servers.
Example:
DNSPriServerIP = 172.16.1.1
DNSSecServerIP = 172.16.1.2
This must be set to “1” in order for faxing to work.
Enables/Disables Fax/Modem determination.
Should be set to “0”
Enables/Disables Fax/Modem determination.
Should be set to “0”
Enables/Disables Fax/Modem determination.
Should be set to “0”
Enables/Disables Fax/Modem determination.
Should be set to “0”
6 Redundant Proxy Configuration
The following configuration options are found under Protocol
Management/Protocol Definition/Proxy & Registration in the web interface. In
order for the Mediant 2000 to function with redundant proxies, the following
value must be set:
IP Address of the primary proxy.
First Redundant Proxy IP Address
IP Address of the secondary proxy.
Values: Homing, Parking
Homing: Gateway will ALWAYS try the primary
proxy on every call attempt.
Parking: Gateway will “park” on the last known
good proxy until that proxy fails.
Value: Using Options
Gateway will sent OPTIONS messages to verify a
proxy is online.
Value: Enabled
Gateway will attempt proxy failover if this is not
set.
The following parameters are optional and enable advanced failover
capabilities:
Enable Fallback to Routing Table
If none of the configured proxies are available, the
gateway will attempt to deliver the call based upon
its internal routing Tel to IP routing table.
How often (in seconds) the OPTIONS messagew will
be sent to verify a proxy is online.
Number of RTX Before Hot-Swap
How many re-transmits before failover takes place.
Comentarios a estos manuales