
Dialogic
®
Brooktrout
®
SR140 Fax Software with AudioCodes MediaPack
TM
Gateway
Installation and Configuration Integration Note
5
3. Prerequisites
No special requirements to note.
4. Summary of Limitations
TCP cannot be used as a SIP Transport Type because the SR140 software does not support SIP over TCP.
This parameter should be set to UDP on the MP-114 SIP General Parameters screen.
5. Dialogic
®
Brooktrout
®
SR140 Fax Software Setup Notes
For the sample test configuration, the SR140 was configured using the default values, consult the
Dialogic
®
Brooktrout
®
Fax Products Installation and Configuration Guide for details.
The Installation and Configuration Guide for SDK 6.1.x is available from the site below:
http://www.dialogic.com/manuals/brooktrout/default.htm
6. Dialogic
®
Brooktrout
®
TR1034 Fax PSTN Setup Notes
For the sample test configuration, the TR1034 was configured using the default values, consult the
Dialogic
®
Brooktrout
®
Fax Products Installation and Configuration Guide for details.
7. AudioCodes MediaPack
TM
Gateway Setup Notes
7.1 AudioCodes MP-114 FXS Configuration
For the sample test configuration, the following instructions were used to configure the AudioCodes MediaPack
MP-114 FXS for T.38 faxing. For more information on the parameters described below, refer to the AudioCodes
User’s Guide.
1. Access board’s web interface (http://xx.xx.xx.xx
)
2. Default password and username: Admin
Comentarios a estos manuales