AudioCodes MP-201B Manual de usuario descargar pdf (Pagina 8)

Star2Star Communications Star2Star – StarFax Classic Configuration Guide

Second Edition www.star2star.com Page 8 of 15

Copyright © 2013, Star2Star Communications, LLC. All rights reserved. Star2Star is a registered Trademark of Star2Star Communications. Copyright © 2013, Star2Star Communications, LLC. All rights reserved. Star2Star is a registered Trademark of Star2Star Communications.

Connecting an AudioCodes MP-20x ATA and Fax Machine

1. Complete the following connections for correct StarFax Classic setup.

2. Connect the Fax AudioCodes MP-20x as per the picture below:

3. When correctly connected (connect power last) the device will register.

4. The Green LAN, WAN, and POWER LED’s will show Green. The STATUS LED will show Red.

5. The Green LAN LED will go out and after approximately 45 seconds the STATUS LED will turn Green.

6. At this point the Fax AudioCodes MP-20x has registered (see picture below 3 steady green LED’s WAN,

STATUS and POWER).

7. The following Fax settings must be applied for StarFax Classic to work successfully:

! Set the Fax machine speed to 14.4 kbps bps

! Set the ECM (Error Correction Mode) to OFF

Plug the telephone

cable from the Fax

line connection into

the PHONE 1

connector on the ATA

Plug the Cat 5 cable

required for

StarSystem network

connection into WAN

connector

Power

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios

AudioCodes MP-201B Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Redes AudioCodes MP-201B