AudioCodes Mediant 3000 Manual de usuario descargar pdf (Pagina 62)

AudioCodes Mediant E-SBC 62 Document #: LTRT-40821

Microsoft Lync and XO Technology SIP Trunk

4.12 Step 12: Configure IP-to-IP Manipulation Rules

This step describes how to configure IP-to-IP manipulation rules. These rules manipulate

the source and / or destination number. The manipulation rules use the configured IP

Groups to denote the source and destination of the call. As configured in Section 4.5 on

page 42, IP Group 1 represents Lync Server 2013, and IP Group 2 represents XO

Communications SIP Trunk.

Note: Adapt the manipulation table according to you environment dial plan.

For this interoperability test topology, a manipulation is configured to add the "+" (plus sign)

to the destination number for calls from IP Group 2 (XO Communications SIP Trunk) to IP

Group 1 (i.e., Lync Server 2013) for any destination username prefix.

 To configure a number manipulation rule:

1. Open the IP-to-IP Outbound Manipulation page (Configuration tab > VoIP menu >

SBC > Manipulations SBC > IP-to-IP Outbound).

2. Click Add.

3. Click the Rule tab, and then configure the parameters as follows:

Parameter Value

Index

Source IP Group

Destination IP Group

Destination Username Prefix

* (asterisk sign)

Manipulated URI

Destination

Figure 4-35: Configuring IP-to-IP Outbound Manipulation Rule – Rule Tab

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 77 78

Sin comentarios

AudioCodes Mediant 3000 Manual de usuario Pagina 62