AudioCodes Mediant TP-1610 H.323 Manual de usuario descargar pdf (Pagina 221)

SIP User's Manual 8. Telephony Capabilities

Version 5.0 221 October 2006

8.10 Trunk to Trunk Routing Example

This example describes two AudioCodes gateways, each interface with the PSTN through

four E1 spans. Gateway ‘A’ is configured to route all incoming TelÆIP calls to gateway ‘B’.

Gateway ‘B’ generates calls to PSTN on the same E1 Trunk as the call was originally

received (in gateway ‘A’).

 Gateway ‘A’ IP address is 192.168.3.50

 Gateway ‘B’ IP address is 192.168.3.51

Ini File Parameters of Gateways ‘A’ and ‘B’:

1. Define, for both gateways, four trunk groups; each with 30 B-channels:

• TrunkGroup_1 = 0/1-31,1000

• TrunkGroup_2 = 1/1-31,2000

• TrunkGroup_3 = 2/1-31,3000

• TrunkGroup_4 = 3/1-31,4000

2. In gateway ‘A’, add the originating Trunk Group ID, as a prefix, to the destination

number, for TelÆIP calls:

AddTrunkGroupAsPrefix=1

3. In gateway ‘A’, route all incoming PSTN calls, starting with the prefixes 1, 2, 3 and 4,

to gateway’s ‘B’ IP address:

• Prefix = 1, 192.168.3.51

• Prefix = 2, 192.168.3.51

• Prefix = 3, 192.168.3.51

• Prefix = 4, 192.168.3.51

Note: It is also possible to define ‘Prefix = *,192.168.3.51’ instead of the four lines

above.

4. In gateway ‘B’, route IPÆPSTN calls to Trunk Group ID according to the first digit of

the called number:

• PSTNPrefix = 1,1

• PSTNPrefix = 2,2

• PSTNPrefix = 3,4

• PSTNPrefix = 4,4

5. In gateway ‘B’, remove the first digit from each IPÆPSTN number, before it is used in

an outgoing call:

NumberMapIP2Tel = *,1

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 403 404

Sin comentarios

AudioCodes Mediant TP-1610 H.323 Manual de usuario Pagina 221