AudioCodes Mediant 600 Manual de usuario descargar pdf (Pagina 240)

100

101

SIP User's Manual 240 Document #: LTRT-83303

Mediant 1000 & Mediant 600

Parameter Description

Enable Calling Party Category

[EnableCallingPartyCategory]

Determines whether Calling Party Category (CPC) is mapped

between SIP and PRI.

 [0] Disable = Don't relay the CPC between SIP and PRI

(default).

 [1] Enable = The CPC is relayed between SIP and PRI.

If enabled, the CPC received in the Originating Line Information

(OLI) IE of an incoming ISDN SETUP message is relayed to the

From / P-Asserted-Identity headers using the 'cpc' parameter, in

the outgoing INVITE message, and vice versa.

For example (calling party is a payphone):

From:<sip:2000;cpc=payp[email protected]>;tag=1c1806157451

Note: This feature is supported only when using the NI-2 PRI

variant.

Digital Out-Of-Service Behavior

[DigitalOOSBehavior]

Determines the method for setting digital trunks to Out-Of-Service

state per device.

 [0] Default = Uses default behavior for each trunk - see note

below (default)

 [1] Service = Sends ISDN In or Out of Service (only for ISDN

protocols that support Service message).

 [2] D-Channel = Takes D-Channel down or up (ISDN only).

 [3] Alarm = Sends or cleans PSTN AIS Alarm (ISDN and CAS).

 [4] Block = Blocks trunk (CAS only).

Notes:

 The default behavior (value 0) is as follows:

- ISDN: Use Service messages on supporting variants and use

Alarm on non-supporting variants.

- CAS: Use Alarm.

 When updating this parameter value at run-time, you must stop

the trunk and then restart it for the update to take effect.

 To determine the method for setting Out-Of-Service state per

trunk, use the DigitalOOSBehaviorFor Trunk_ID parameter

(refer to ''Trunk Settings'' on page 96).

MLPP (Multilevel Precedence and Preemption)

Call Priority Mode

[CallPriorityMode]

Enables Priority Calls handling.

 [0] Disable = Disable (default).

 [1] MLPP = Priority Calls handling is enabled.

MLPP Default Namespace

[MLPPDefaultNamespace]

Determines the Namespace used for MLPP calls received from the

ISDN side and destined for the Application server. The

Namespace value is not present in the Precedence IE of the PRI

SETUP message. Therefore, the value is used in the Resource-

Priority header of the outgoing SIP INVITE request.

 [1] DSN = DSN (default)

 [2] DOD = DOD

 [3] DRSN = DRSN

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 567 568

Comentarios a estos manuales

Sin comentarios

AudioCodes Mediant 600 Manual de usuario Pagina 240

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes Mediant 600