AudioCodes Mediant 600 Manual de usuario Pagina 502
- Pagina / 568
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
SIP User's Manual 502 Document #: LTRT-83303
Mediant 1000 & Mediant 600
Hard Drive module (HDMX)
Figure 12-3: Hard Drive Module (HDMX)
Warning: Before installing the Mediant 1000 OSN Server modules, ensure that the
Mediant 1000 is disconnected from the power supply. These modules are not
hot-swappable and damage to these modules can occur if replaced under
voltage.
12.2 Required Working Tools
The following tools are required for installing the OSN Server module:
Phillips screwdriver
Flathead screwdriver
Wire cutter
12.3 Installing the CM Module
The Connection Module (CM) is installed on the front panel of the Mediant 1000, as
described in the following procedure:
- User's Manual 1
- Table of Contents 3
- List of Figures 10
- List of Tables 14
- Reader's Notes 16
- Trademarks 17
- WEEE EU Directive 17
- Customer Support 17
- Related Documentation 18
- 1 Overview 19
- 1.2 Mediant 600 20
- 1.3 SIP Overview 21
- 2 Configuration Concepts 23
- 3 Web-Based Management 25
- 3.3.1 Toolbar 28
- 3.3.2 Navigation Tree 29
- 3.3.3.1 Accessing Pages 32
- 3.3.3.2 Viewing Parameters 32
- 3.3.3.5 Working with Tables 36
- 3.3.5 Working with Scenarios 40
- 3.3.5.3 Editing a Scenario 43
- 3.3.5.6 Deleting a Scenario 46
- 3.3.7 Getting Help 52
- 3.3.8 Using the Home Page 52
- Red: Fan tray failure 57
- 3.3.8.5 Replacing Modules 61
- 3.4 Configuration Tab 64
- [2] PassThrough = N/A 67
- [0] Auth NULL 75
- [1] Auth UNIX (default) 75
- [0] = OAMP 75
- [1] = Media (default) 75
- [0] = OAMP (default) 77
- [1] = Media 77
- [2] = Control 77
- 3.4.2 Media Settings 80
- [2] Bypass 84
- [3] Events Only 84
- 3.4.3 PSTN Settings 96
- 3.4.4 Security Settings 111
- 3.4.5 Protocol Configuration 133
- [0] Disable 135
- [1] Supported (default) 135
- [2] Required 135
- [1] Enable = Enable 143
- [1] Enable = Enabled 150
- [1] SRV = SRV 150
- [2] NAPTR = NAPTR 150
- 3.4.5.1.3 Proxy Sets Table 153
- 5 steps: 154
- 3.4.5.1.4 Coders 157
- • x: Any single digit 163
- 3.4.5.2.3 Metering Tones 182
- 3.4.5.2.5 Keypad Features 184
- 4 steps: 189
- [9] Private = Private 196
- 3.4.5.6.1 Authentication 219
- 3.4.5.6.2 Automatic Dialing 220
- 3.4.5.6.4 Call Forward 222
- 3.4.5.6.6 Call Waiting 225
- Disable (default) 232
- 0 = Disable 234
- 1 = Enable 234
- [0] 0 = ROUTINE (default) 241
- [2] 2 = PRIORITY 241
- [6] 6 = IMMEDIATE 241
- [8] 8 = FLASH-OVERRIDE 241
- 3.4.6 Advanced Applications 244
- [1] Alaw = Alaw (default) 252
- [3] MuLaw = MuLaw 252
- 3.5 Management Tab 253
- 3.5.1.3 Maintenance Actions 262
- 2 steps: 265
- 3.5.2 Software Update 266
- 6 steps: 271
- 3.6.2 Gateway Statistics 283
- 3.6.2.2 Call Routing Status 286
- 3.6.2.3 Registration Status 287
- 3.6.2.5 IP Connectivity 289
- 4 ini File Configuration 291
- 4.2 The ini File Structure 292
- 4.3 Modifying an ini File 296
- 4.4.2 System Parameters 305
- [10] = 100000 307
- [1] = Enable RAI service 307
- [0] = Disabled (default) 313
- 4.4.4 Security Parameters 314
- 4.4.5 RADIUS Parameters 320
- 4.4.6 SNMP Parameters 321
- [0] Disable (default) 326
- [1] Enable 326
- [1] = Enabled 332
- 4.4.9 Voice Mail Parameters 343
- 4.4.10 PSTN Parameters 344
- [1] = User-to-User 350
- [0] = Disable (default) 355
- [1] = Enable 355
- 4.4.14 Channel Parameters 377
- 5 Default Settings 385
- 6.5 Coefficient File 393
- 6.6 Dial Plan File 393
- 6.7 User Information File 395
- 7 IP Telephony Capabilities 397
- 7.2.2.1 T.38 Fax Relay Mode 399
- 7.2.2.5 Fax Fallback 402
- 7.2.3 Supporting V.34 Faxes 404
- 7.3 FXO Operating Modes 406
- 7.3.1.2 Two-Stage Dialing 408
- 7.3.1.4 DID Wink 409
- 7.3.2 Telephone-to-IP Calls 410
- Connectivity and QoS) 415
- 7.7.4 Relevant Parameters 416
- 7.9 Call Detail Record 417
- 7.13 Configuration Examples 423
- PSTN, take this step: 431
- 7.14.3 Call Transfer 438
- 7.14.4 Call Forward 439
- 7.14.5 Call Waiting 440
- 7.14.7 Caller ID 441
- 8 Networking Capabilities 445
- 8.3.1 STUN 447
- 8.4 IP Multicasting 448
- 8.9 VLANS and Multiple IPs 450
- Control: Premium control 453
- Management: Bronze 453
- 9.1 Clock Settings 459
- 9.2 Release Reason Mapping 459
- 9.2.1 Reason Header 460
- 9.3 ISDN Overlap Dialing 463
- 9.4 Using ISDN NFAS 464
- 9.4.1 NFAS Interface ID 465
- 10.1 Conference Server 469
- 10.1.1.1 SIP Call Flow 470
- 10.1.1.5 PSTN Participants 472
- 10.2 Announcement Server 483
- 10.2.2 MSCML Interface 484
- 10.2.2.1 Operation 485
- 10.2.2.6 Relevant Parameters 491
- 10.3 IP-to-IP Transcoding 494
- 11 Tunneling Applications 497
- 11.2 QSIG Tunneling 500
- 12.1 OSN Server Modules 501
- 12.2 Required Working Tools 502
- 13.1 Requirements 509
- 13.3.1 Cabling 519
- 14.1 Requirements 523
- 14.2 Cabling 524
- RedHat™ EL 4+) 534
- 14.5 Installing Linux™ SUSE 544
- 16.1 Mediant 1000 557
- 16.2 Mediant 600 561
- 17 Glossary 565
- Terminal Equipment (ISDN) 567
- Voice Prompts (File) 567
Relacionado con productos y manuales para Gateways / Controladores AudioCodes Mediant 600
(46 paginas)
(44 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales