AudioCodes Mediant 600 Manual de usuario descargar pdf (Pagina 369)

100

101

Version 5.4 369 May 2008

SIP User's Manual 4. ini File Configuration

ini File Parameter Description

SwapTel2IPCalled&Calling

Numbers

If enabled, the device swaps the calling and called numbers received

from the Tel side. The INVITE message contains the swapped numbers.

Applicable for Tel-to-IP calls.

 [0] = Disabled (default)

 [1] = Swap calling and called numbers

AddTON2RPI

For a description of this parameter, refer to ''SIP General Parameters''

on page 134.

NumberMapTel2IP

This ini file table parameter manipulates manipulates the destination

number of Tel-to-IP calls. The format of this parameter is as follows:

[NumberMapTel2Ip]

FORMAT NumberMapTel2Ip_Index =

NumberMapTel2Ip_DestinationPrefix,

NumberMapTel2Ip_SourcePrefix,

NumberMapTel2Ip_SourceAddress, NumberMapTel2Ip_NumberType,

NumberMapTel2Ip_NumberPlan,

NumberMapTel2Ip_RemoveFromLeft,

NumberMapTel2Ip_RemoveFromRight,

NumberMapTel2Ip_LeaveFromRight, NumberMapTel2Ip_Prefix2Add,

NumberMapTel2Ip_Suffix2Add,

NumberMapTel2Ip_IsPresentationRestricted;

[\NumberMapTel2Ip]

Where,

 DestinationPrefix = Destination number prefix.

 SourcePrefix = Source number prefix.

 SourceAddress = N/A.

 NumberType = Number Type used in RPID header.

 NumberPlan = Number Type used in RPID header.

 RemoveFromLeft = Number of stripped digits from the left.

 RemoveFromRight = Number of stripped digits from the right.

 LeaveFromRight = Number of remaining digits from the right.

 Prefix2Add = String to add as prefix.

 Suffix2Add = String to add as suffix.

 IsPresentationRestricted = N/A (set to $$).

For example:

[NumberMapTel2Ip]

NumberMapTel2Ip 0 = 01,$$,*,0,0,2,$$,$$,971,$$,$$;

NumberMapTel2Ip 1 = 10,10,*,255,255,3,0,5,100,$$,255;

[\NumberMapTel2Ip]

Notes:

 RemoveFromLeft, RemoveFromRight, Prefix2Add, Suffix2Add,

LeaveFromRight, NumberType, and NumberPlan are applied if the

called and calling numbers match the DestinationPrefix and

SourcePrefix conditions.

 The manipulation rules are executed in the following order:

RemoveFromLeft, RemoveFromRight, LeaveFromRight, Prefix2Add,

and Suffix2Add.

 Parameters can be skipped by using two dollar signs ('$$').

 Number Plan and Type can optionally be used in Remote Party ID

1 2 ... 364 365 366 367 368 369 370 371 372 373 374 ... 567 568

Comentarios a estos manuales

Sin comentarios

AudioCodes Mediant 600 Manual de usuario Pagina 369

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes Mediant 600