AudioCodes MEDIAPACK VERSION 6.2 Manual de instalación descargar pdf (Pagina 15)

Version 6.2 15 February 2011

Installation Manual 2. Installing the Device

3. Attach the shelf to the rack using four standard rack screws (not supplied).

Figure 2-5: MP-11x Rack Mount

Table 2-3: MP-11x Rack Mount

Item # Functionality

Standard rack holes used to attach the shelf to the rack.

Eight shelf-to-device screws.

2.1.4 Cabling MP-11x

This section describes the MP-11x cabling procedures:

¾ To cable MP-11x:

 Connecting to the Ethernet network (refer to 'Connecting MP-11x to the Network' on

page 16).

 Connecting to FXS/FXO devices (refer to 'Connecting MP-11x to FXS/FXO Devices'

on page 16).

 Cabling the FXS Lifeline (refer to 'Cabling MP-11x FXS Lifeline' on page 17).

 Serial connection to a computer (refer to 'Connecting MP-11x RS-232 Port to a PC' on

page 19).

 Connecting to the power supply (refer to 'Connecting MP-11x to Power' on page 20).

Once you have completed the above hardware installation steps and after powering-up MP-

11x, the Ready and Power LEDs on the front panel light up green (after a self-testing

period of about two minutes). Any malfunction in the startup procedure changes the Fail

LED to red and the Ready LED is turned off (for details on the MP-11x LEDs, refer to

'Monitoring Front-Panel LEDs' on page 55). O

nce you have cabled the device, you can

begin configuring the device (refer to 'Configuring the Device' on page 35).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Sin comentarios

AudioCodes MEDIAPACK VERSION 6.2 Manual de instalación Pagina 15