AudioCodes MEDIAPACK VERSION 6.2 Manual de instalación descargar pdf (Pagina 19)

Version 6.2 19 February 2011

Installation Manual 2. Installing the Device

2.1.4.4 Connecting MP-11x RS-232 Port to a PC

Follow the procedure below to connect the MP-11x serial (RS-232) interface to a PC using

a straight-through, PS/2 to DB-9 cable adaptor.

Notes:

• This procedure is not applicable to MP-112 as this model does not

provide an RS-232 serial interface port.

• The PS/2 to DB-9 cable adaptor is not included in the MP-11x package.

¾ To connect MP-11x to a PC:

1. Connect the PS/2 connector (refer to the figure below for connector pinouts) on one

end of the cable to the MP-11x RS-232 port (labeled RS-232).

2. Connect the DB-9 connector at the other end of the cable to either the COM1 or COM2

RS-232 communication port on your PC.

Figure 2-11: PS/2 to DB-9 Adaptor Connector Pinouts

Figure 2-12: PS/2 Connector Pinouts

For information on establishing a serial communications link with MP-11x, refer to

‘Assigning an IP Address Using the CLI’ on page 41.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

Sin comentarios

AudioCodes MEDIAPACK VERSION 6.2 Manual de instalación Pagina 19