AudioCodes MP-1FXO Manual de usuario descargar pdf (Pagina 120)

MediaPack

SIP User's Manual 120 Document #: LTRT-65408

5.5.9.2 Automatic Dialing

Use the Automatic Dialing Table to define telephone numbers that are automatically dialed

when a specific port is used.

To configure the Automatic Dialing table, take these 6 steps:

1. Open the ‘Automatic Dialing’ screen (Protocol Management menu > Endpoint

Settings submenu > Automatic Dialing option); the ‘Automatic Dialing’ screen is

displayed.

Figure 5-28: Automatic Dialing Table Screen

2. In the ‘Destination Phone Number’ field for a port, enter the telephone number to dial.

3. From the ‘Auto Dial Status’ drop-down list, select one of the following:

• Enable [1]: When a port is selected, when making a call, the number in the

Destination Phone Number field is automatically dialed if phone is offhooked (for

FXS gateways) or ring signal is applied to port (FXO gateways).

• Disable [0]: The automatic dialing option on the specific port is disabled (the

number in the Destination Phone Number field is ignored).

• Hotline [2]: When a phone is offhooked and no digit is pressed for

‘HotLineToneDuration’, the number in the Destination Phone Number field is

automatically dialed (applies to FXS and FXO gateways).

4. Repeat step 3 for each port you want to use for Automatic Dialing.

5. Click the Submit button to save your changes.

6. To save the changes so they are available after a power fail, refer to Section 5.10.2 on

page 205.

Notes:

• After a ring signal is detected, on an ‘Enabled’ FXO port, the

gateway initiates a call to the destination number without seizing the

line. The line is seized only after the call is answered.

• After a ring signal is detected on a ‘Disabled’ or ‘Hotline’ FXO port,

the gateway seizes the line.

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 389 390

Sin comentarios

AudioCodes MP-1FXO Manual de usuario Pagina 120