AudioCodes MP-1FXO Manual de usuario descargar pdf (Pagina 370)

MediaPack

SIP User's Manual 370 Document #: LTRT-65408

2. The wizard then analyzes the recorded Call Progress Tones and displays a message

specifying the tones that were detected (by the gateway) and analyzed (by the wizard)

correctly. At the end of a successful detection operation, the detected Call Progress

Tones are displayed in the Tones Analyzed pane (refer to Figure E-8).

Figure E-8: Recording Screen after Automatic Detection

3. All four Call Progress Tones are saved (as standard A-law PCM at 8000 bits per

sample) in the same directory as the CPTWizard.exe file is located, with the following

names:

• cpt_recorded_dialtone.pcm

• cpt_recorded_busytone.pcm

• cpt_recorded_ringtone.pcm

• cpt_recorded_invalidtone.pcm

Notes:

• If the gateway is configured correctly (with a Call Progress Tones

dat file loaded to the gateway), all four Call Progress Tones are

detected by the gateway. By noting whether the gateway detects the

tones or not, you can determine how well the Call Progress Tones

dat file matches your PBX. During the first run of the CPTWizard, it

is likely that the gateway does not detect any tones.

• Some tones cannot be detected by the MediaPack gateway

hardware (such as 3-frequency tones and complex cadences).

CPTWizard is therefore limited to detecting only those tones that

can be detected on the MediaPack gateway.

At this stage, you can either click Next to generate a Call Progress Tones ini file and

terminate the wizard, or continue to manual recording mode.

1 2 ... 365 366 367 368 369 370 371 372 373 374 375 ... 389 390

Sin comentarios

AudioCodes MP-1FXO Manual de usuario Pagina 370