AudioCodes Mediant 3000 Manual de usuario descargar pdf (Pagina 30)

Microsoft Lync and ThinkTel SIP Trunk

AudioCodes Mediant E-SBC Series 30 Document #: LTRT-38110

4.1 Step 1: System Network Configuration

This step describes configuring the E-SBC device's Network Setting. There are several

ways to deploy the E-SBC. This document covers only this scenario:

The E-SBC interfaces between enterprise users located in the LAN and the ThinkTel SIP

Trunk located in the WAN. The connection between the E-SBC and the WAN is through a

DMZ network.

Figure 4-2: Network Interfaces

4.1.1 Configure Network Interfaces

This section shows the typical physical LAN port connections of the E-SBC deployed in the

enterprise. The type of physical LAN connection depends on the method used to connect

to the enterprise's network.

In this example E-SBC connects to LAN and WAN using dedicated LAN ports (i.e., two

ports and network cables) and with two logical network interfaces at the enterprise–one to

the LAN (VLAN 1) and one to the WAN (VLAN 2).

The Multiple Interface Table page allows you to configure the IP addresses, DG, and

VLANs for the device, one for each of the following interface names:

 LAN VoIP (Voice)

 WAN VoIP (WanSP)

¾ To configure the interface table:

1. Open the Multiple Interface Table page (Configuration > Network Settings > IP

Settings).

Figure 4-3: Multiple Interface Table

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 62 63

Sin comentarios

AudioCodes Mediant 3000 Manual de usuario Pagina 30