AudioCodes Mediant 3000 Manual de usuario Pagina 50

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 63
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 49
Microsoft Lync and ThinkTel SIP Trunk
AudioCodes Mediant E-SBC Series 50 Document #: LTRT-38110
4.10 Step 10: Configure IP-to-IP Call Routing Rules
This step shows how to configure The IP2IP Routing Rules. This table defines rules for
transferring SIP messages (e.g., INVITE), received at one IP interface, to another interface.
The message is routed according to a rule whose configured input characteristics (e.g.,
Source IP Group) match those of the message. If the characteristics of an incoming
message do not match the first rule in the table, they're then compared by the second rule,
and so on, until a matching rule is located. If no rule is matched, the message is rejected.
You need to add IP-to-IP routing rules for the following routing directions:
Calls from the LAN side to the WAN side.
Calls from the WAN side to the LAN side.
Figure 4-28: IP-to-IP Routing Table
¾ To route from an internal to an external IP Group:
1. Open the IP2IP Routing Table page (Configuration > VoIP > SBC > Routing SBC >
IP to IP Routing Table).
2. Click Add and add a rule for index 1 to the table.
Figure 4-29: Internal IP-to-IP Routing Configuration
3. From the 'Source IP Group ID' drop-down list, select 1.
4. From the 'Destination Type' drop-down list, select IP Group.
5. From the 'Destination IP Group ID' drop-down list, select 2.
6. Click Submit.
Vista de pagina 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 62 63

Comentarios a estos manuales

Sin comentarios