AudioCodes MEDIAPACK VERSION 6.2 Manual de usuario Pagina 31
- Pagina / 180
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
User's Manual 3. Installing the MediaPack
Version 2.2 31 July 2007
Connecting the RS-232 serial interface (refer to Section 'Connecting the RS-232
Serial Interface' on page 34)
Connecting the Lifeline port (refer to Section 'Connecting the Lifeline Port' on page 34)
Connecting the PSTN Fallback port (refer to Section 'Connecting the PSTN Fallback
Port' on page 36)
Connecting to Power (refer to Section 'Connecting the Power Source' on page 37)
3.4.1 Connecting the LAN Interface
The MediaPack provides a LAN interface port for connection to a local area network (LAN).
The cable and connector requirements for LAN cabling are as follows:
Cable: straight-through Cat 5 cable.
Connector: 8-pin RJ-45.
Connector Pinouts: refer to the figure below:
Figure 3-4: RJ-45 Ethernet Connector Pinouts
1 2 3 4 5 6 7 8
RJ-45 Connector and Pinout
4, 5, 7, 8
not
connected
1 - Tx+
2 - Tx-
3 - Rx+
6 - Rx-
¾ To connect the MediaPack to the LAN:
1. Connect the RJ-45 connector, at the one end of the Ethernet Cat 5 cable (supplied), to
the MediaPack's LAN port (labeled LAN).
2. Connect the other end of the cable directly to your network (e.g., switch or PC).
3.4.2 Connecting the WAN Interface
The MediaPack provides a WAN interface port for connection to the wide area network
(WAN).
The cable and connector requirements for WAN cabling are as follows:
Cable: straight-through Cat 5 cable.
Connector: 8-pin RJ-45.
Connector Pinouts: refer to the figure below.
Figure 3-5: RJ-45 Ethernet Connector Pinouts
1 2 3 4 5 6 7 8
RJ-45 Connector and Pinout
4, 5, 7, 8
not
connected
1 - Tx+
2 - Tx-
3 - Rx+
6 - Rx-
- User’s Manual 1
- Table of Contents 3
- List of Figures 7
- List of Tables 9
- Reader's Notes 10
- Customer Support 11
- Trademarks 11
- WEEE EU Directive 11
- Typographical Conventions 12
- Related Documentation 12
- 1 Overview 15
- 1.2 Gateway Description 16
- 1.3 SIP Overview 17
- 1.4 MediaPack Features 18
- 1.4.3 Telephony Capabilities 20
- 1.4.3.1.3 Call Forward 21
- 1.4.3.1.4 Call Waiting 21
- 2.1 Physical Description 23
- 2.1.2 Rear Panel 24
- 3 Installing the MediaPack 27
- 3.3 Mounting the MediaPack 28
- 3.4 Cabling the MediaPack 30
- RJ-45 Connector and Pinout 31
- Connector: 8-pin RJ-45 32
- 4 Initial Configuration 39
- ♦ Dest IP: 0.0.0.0 44
- ♦ Dest Mask: 0.0.0.0 44
- ♦ DHCP: 48
- ♦ PPPoE: 48
- General SIP parameters 54
- SIP users 54
- 5.1 Configuration Concepts 63
- 5.2 Embedded Web Server 64
- 5.2.1 Computer Requirements 65
- 5.2.3 Main Menu Bar 66
- 5.2.5 Dialing Notations 67
- 5.3.1 Logging into the CLI 68
- 5.3.2 CLI Modes 69
- 5.3.3 Navigating in the CLI 70
- Version 2.2 75 July 2007 75
- Version 2.2 77 July 2007 77
- 6.1 Quick Setup 79
- 6.2 Protocol Management 79
- 6.2.1 SIP Gateway 80
- 5.3 on page 68 86
- 6.2.1.3 SIP Users 87
- ¾ To configure SIP users: 87
- 6.2.2 ISDN 88
- ¾ To define a tone-set: 92
- 6.2.2.4 Hunt Logic 98
- 6.2.2.5 Manipulation Tables 98
- 6.2.3 Routing Tables 106
- Destination phone prefix 108
- Source phone prefix 108
- Source IP address 108
- Version 2.2 109 July 2007 109
- 6.2.4 Profile Definitions 110
- MediaPack BRI Series 112
- nte 112
- 6.2.4.2 ISDN Profiles 113
- Version 2.2 117 July 2007 117
- 6.3 Advanced Configuration 118
- Version 2.2 121 July 2007 121
- Parameter Description 121
- 6.3.1.2 PPPoE 122
- 6.3.1.3 Static Routes 123
- ¾ To add static routes: 124
- 6.3.1.4 Dynamic Routes 125
- 6.3.1.5 QoS 126
- ¾ To configure QoS: 127
- 6.3.1.7 Access Control List 131
- 6.3.1.8 NAT 134
- Version 2.2 135 July 2007 135
- 6.3.1.9 RIP 136
- 6.3.1.10 Services 137
- <hh:mm:ss> 139
- 6.3.2 User Management 140
- 6.4.1 System Information 142
- 6.4.2 ISDN Ports Status 143
- 6.5 Software Upgrade 144
- Version 2.2 145 July 2007 145
- <source> 148
- Valid options include: 148
- Version 2.2 153 July 2007 153
- 6.7 Resetting the MediaPack 154
- A MediaPack Applications 155
- A.4.2 Call Transfer 169
- A.4.3 Call Forward 170
- A.4.5 Overlap Receiving 172
- A.4.6 MSN 172
- B MediaPack Startup Process 173
- C Technical Specifications 175
Relacionado con productos y manuales para Redes AudioCodes MEDIAPACK VERSION 6.2
Redes AudioCodes Mediant 800 MSBR Manual de usuario
(14 paginas)
(14 paginas)
Redes AudioCodes MP-201B Manual de usuario
(15 paginas)
(15 paginas)
Redes AudioCodes Mediant 800 MSBR Manual de usuario
(66 paginas)
(66 paginas)
Redes AudioCodes MP-1FXO Manual de usuario
(390 paginas)
(390 paginas)
Redes AudioCodes MEDIAPACK VERSION 6.2 Manual de usuario
(294 paginas)
(294 paginas)
Redes AudioCodes Mediant 800 MSBR Manual de usuario
(81 paginas)
(81 paginas)
Redes AudioCodes Mediant 800 MSBR Manual de usuario
(47 paginas)
(47 paginas)
Redes AudioCodes MP-20x Guía de instalación
(26 paginas)
(26 paginas)
Redes AudioCodes MEDIAPACK VERSION 6.2 Especificaciones
(178 paginas)
(178 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.072 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales