AudioCodes MEDIAPACK VERSION 6.2 Manual de usuario descargar pdf (Pagina 49)

User's Manual 4. Initial Configuration

Version 2.2 49 July 2007

d. Enable the new configuration by typing the following command:

192.168.2.1(IF-IP)[WAN]# shutdown <CR>

192.168.2.1(IF-IP)[WAN]# no shutdown <CR>

e. Verify the new WAN IP settings by typing the following command:

192.168.2.1(if-ip)[WAN]# show ip interface WAN <CR>

f. Exit the WAN mode using the following command:

192.168.2.1(if-ip)[WAN]# exit <CR>

g. Continue to Step 6 to configure the default gateway IP address.

6. Configure the default gateway (relevant to Static and PPPoE WAN interface modes),

by typing the following command:

192.168.2.1(cfg)#

192.168.2.1(cfg)#context ip router <CR>

192.168.2.1(ctx-ip)[router]#route 0.0.0.0 0.0.0.0 <Default

Gateway IP> <CR>

In our example setup, the default gateway is defined as 10.33.0.1.

7. Save the configuration by typing the following command:

192.168.2.1 # store-running-config

For additional information on configuring the network settings, refer to Section 'Network

Settings' on page 118.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 179 180

Sin comentarios

AudioCodes MEDIAPACK VERSION 6.2 Manual de usuario Pagina 49