AudioCodes Mediant 3000 Manual de usuario descargar pdf (Pagina 69)

Configuration Note 4. Configuring AudioCodes E-SBC

Connecting Microsoft Lync 2013 to a SIP Trunk 69 June 2013

4.13 Step 13: Configuring SIP Message Manipulation

Rules

This step shows how to configure SIP message manipulation rules (configured in the

Message Manipulations table).

SIP message manipulation rules can include insertion, removal and/or modification of SIP

headers. Multiple manipulation rules can be configured for the same SIP message. After

configuring the SIP message manipulation rules, assign them to the relevant IP Group (in

the IP Group table) and determine whether they must be applied to inbound or outbound

messages.

See an example below of a message manipulation rule configuration; use the E-SBC

User's Manual for detailed instructions on how to configure message manipulation rules

according to your requirements.

In the example scenario, the configured manipulation rule manipulates the P-Asserted-

Identity user part of the header, and replaces it with the user part that appears on the

Referred-By header.

 To configure SIP message manipulation rules:

1. Open the Message Manipulations page (Configuration tab > VoIP > SIP Definitions

> Msg Policy & Manipulation > Message Manipulations).

Figure 4-37: Message Manipulations Page

2. Add the following manipulation rules for Manipulation Set ID 0:

Parameter Example Setting

Index "0"

Manipulation Set ID "0"

Message Type any

Note: Enter the value as is.

Condition header.referred-by exists

Note: Enter the value as is.

Action Subject header.p-asserted-identity

Note: Enter the value as is.

Action Type

Modify

Action Value '<'+header.referred-by.URL+'>'

Note: Enter the value as is.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 79 80

Sin comentarios

AudioCodes Mediant 3000 Manual de usuario Pagina 69