AudioCodes MediaPack MP-124 Manual de usuario descargar pdf (Pagina 19)

Configuration Note 4. Configuring the Device

Version 6.6 19 September 2013

4 Configuring the Device

This section provides a step-by-step procedure for configuring the device for scenarios

where it is used for connecting the Microsoft Lync environment to the PSTN as well for

scenarios where there are Analog Devices communicating with Lync Server.

The configuration steps described in this section are performed through the embedded

Web server (Web interface) of the Enhanced gateway.

Notes:

• The E-SBC must be installed with a Software Feature Key that includes the

following items:

√ Microsoft

√ SBC

√ Security

√ DSP

√ RTP

√ SIP

For more information about the Key, contact your AudioCodes

representative.

• The scope of this document does not cover security aspects of connecting

a SIP Trunk to the Lync Server environment. Security measures should be

implemented in accordance with your organization’s security policies. For

basic security guidelines, see the Recommended Security Guidelines

Technical Note.

• The E-SBC must be installed with SIP firmware version 6.6 or later.

• Before beginning to configure the E-SBC, select the Full option in the Web

interface to display the full Navigation tree:

When the E-SBC is reset, the Web interface reverts to Basic display.

• This document applies to Microsoft Lync Server 2013.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 97 98

Sin comentarios

AudioCodes MediaPack MP-124 Manual de usuario Pagina 19