AudioCodes MediaPack MP-124 Manual de usuario descargar pdf (Pagina 81)

Configuration Note B. Configuring Lync Server 2013

Version 6.6 81 September 2013

B Configuring Lync Server 2013

This appendix describes how to configure Microsoft Lync Server 2013 topology builder to

operate with AudioCodes device’s entities.

It also describes how to configure an Analog device via the Lync Management Shell.

Note: Routes, Dial plans, voice policies, and PSTN usages are also necessary for

Enterprise voice deployment; however, they are beyond the scope of this

document.

B.1 Configuring the Device as an IP / PSTN Gateway

The procedure below describes how to configure the device as an IP / PSTN Gateway.

You need to configure the following entities:



Gateway entity – ACGW.ilync15.local



SBC entity – ACGW2.ilync15.local

B.1.1 Configuring the Gateway Entity

This section describes how to configure the gateway entity as an IP/PSTN gateway and to

associate it with the Mediation Server.

 To configure the Gateway entity as an IP/PSTN Gateway and associate it with

the Mediation Server:

1. On the server where the Topology Builder is installed, start the Lync Server 2013

Topology Builder (point to Windows Start menu, click All Programs, and then click

Lync Server Topology Builder).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 97 98

Sin comentarios

AudioCodes MediaPack MP-124 Manual de usuario Pagina 81