AudioCodes MediaPack MP-124 Manual de usuario descargar pdf (Pagina 52)

Microsoft Lync Server 2013 52 Document #: LTRT-40127

Enhanced Gateway with Analog Devices

4.13 Step 13: Configuring SBC Classification and Routing

The procedures below describe how to classify and route between the different IP’s

identities (i.e., Lync Server, Gateway entity, Analog device) in the SBC entity.

4.13.1 Configuring Classification Rules

This procedure describes how to configure Classification rules.

Classification rules are used to classify incoming SIP dialog-initiating requests (e.g., SIP

INVITE messages) to source IP Groups, from where the SIP dialog request originated.

In the example scenario, two classification rules are added:



Classification of the Analog Device users. In the example below, the classification is

set upon the Source Host name.

Note that this host name must also be configured on the ATA device (see Section A.8

on page 79).



Classification of the Lync Server for the SBC entity. In the example below, the

classification is set upon the Destination Host name.

Note that this host name must also be configured on the Lync Server (see Section A.8

on page 79).

 To add Classification rules:

1. Open the Classification Table page (Configuration > VoIP > SBC > Routing SBC >

Classification Table).

2. Add a rule to match Source Host to IP Group:

a. Click Add.

b. Configure the parameters as follows:

Parameter Settings

Index 0

Source Host analog.com

Source IP Group ID 5

c. Click Submit.

3. Add a rule to match Destination Host to IP Group:

a. Click Add.

b. Configure the parameters as follows:

Parameter Settings

Index 1

Destination Host ACGW2.ilync15.local

Source IP Group ID 2

c. Click Submit.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 97 98

Sin comentarios

AudioCodes MediaPack MP-124 Manual de usuario Pagina 52