AudioCodes MediaPack 114 Manual de usuario descargar pdf (Pagina 116)

SIP User's Manual 116 Document #: LTRT-65411

MediaPack Series

Parameter Description

Registration Time

[RegistrationTime]

Defines the time interval (in seconds) for registering to a Proxy server.

The value is used in the Expires header. In addition, this parameter

defines the time interval between Keep-Alive messages when the

parameter EnableProxyKeepAlive is set to 2 (REGISTER).

Typically, the device registers every 3,600 sec (i.e., one hour). The

device resumes registration according to the parameter

RegistrationTimeDivider.

The valid range is 10 to 2,000,000. The default value is 180.

Re-registration Timing [%]

[RegistrationTimeDivider]

Defines the re-registration timing (in percentage). The timing is a

percentage of the re-register timing set by the Registrar server.

The valid range is 50 to 100. The default value is 50.

For example: If RegistrationTimeDivider is 70% and Registration

Expires time is 3600, the device re-sends its registration request after

3600 x 70% = 2520 sec.

Note: This parameter may be overriden if the parameter

RegistrationTimeThreshold is greater than 0 (refer to the description of

RegistrationTimeThreshold).

Registration Retry Time

[RegistrationRetryTime]

Defines the time interval (in seconds) after which a Registration

request is resent if registration fails with a 4xx response or if there is

no response from the Proxy/Registrar server.

The default is 30 seconds. The range is 10 to 3600.

Registration Time Threshold

[RegistrationTimeThresho

ld]

Defines a threshold (in seconds) for re-registration timing. If this

parameter is greater than 0, but lower than the computed re-

registration timing (according to the parameter

RegistrationTimeDivider), the re-registration timing is set to the

following: timing set by the Registration server in the Expires header

minus the value of the parameter RegistrationTimeThreshold.

The valid range is 0 to 2,000,000. The default value is 0.

Re-register On INVITE

Failure

[RegisterOnInviteFailure]

Enables immediate re-registration if a failure response is received for

an INVITE request sent by the device.

 [0] Disable = Disabled (default)

 [1] Enable = Enabled

ReRegister On Connection

Failure

[ReRegisterOnConnection

Failure]

Enables the device to perform SIP Re-Registration upon TCP/TLS

connection failure.

 [0] Disable (default).

 [1] Enable.

Miscellaneous parameters

Gateway Name

[SIPGatewayName]

Assigns a name to the device (e.g., 'gateway1.com'). Ensure that the

name you choose is the one with which the Proxy is configured to

identify the device.

Note: If specified, the device name is used as the host part of the SIP

URI in the From header. If not specified, the device's IP address is

used instead (default).

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 389 390

Comentarios a estos manuales

Sin comentarios

AudioCodes MediaPack 114 Manual de usuario Pagina 116

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes MediaPack 114