
SIP User's Manual 56 Document #: LTRT-65411
MediaPack Series
¾ To configure the multiple IP interface table, take these 7 steps:
1. Open the 'IP Settings' page (refer to ''Configuring the IP Settings'' on page 52).
2. Under the Multiple Interface Settings group, click the right-arrow
button alongside
Multiple Interface Table; a confirmation message box appears:
Figure 3-36: Confirmation Message for Accessing the Multiple Interface Table
3. Click OK to confirm; the 'Multiple Interface Table' page appears:
Figure 3-37: Interface Table Page
4. In the 'Add' field, enter the desired index number for the new interface, and then click
Add; the index row is added to the table.
5. Configure the interface according to the table below.
6. Click the Apply button; the interface is immediately applied to the device.
7. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.
Notes:
• When adding more than one interface to the table, ensure that you
enable VLANs, using the 'VLAN Mode' (VlANMode) parameter.
• When booting using BootP/DHCP protocols (refer to the Product
Reference Manual), an IP address is obtained from the server. This
address is used as the OAMP address for this session, overriding the IP
address you configured in the 'Multiple Interface Table' page. The
address specified in this table takes effect only after you save the
configuration to the device's flash memory. This enables the device to
use a temporary IP address for initial management and configuration,
while retaining the address (defined in this table) for deployment.
• For a detailed description on multiple IP interfaces and VLANs, refer to
''VLANS and Multiple IPs'' on page 370.
• For a description of the Web interface's table command buttons (e.g.,
Duplicate and Delete), refer to ''Working with Tables'' on page 32.
Comentarios a estos manuales