AudioCodes MediaPack 114 Manual de usuario descargar pdf (Pagina 184)

SIP User's Manual 184 Document #: LTRT-65411

MediaPack Series

Parameter Description

Channel Select Mode

[TrunkGroupSettings_ChannelS

electMode]

The method in which IP-to-Tel calls are assigned to channels

pertaining to a Hunt Group:

 [0] By Dest Phone Number = Selects the device's channel

according to the called number defined in the 'Endpoint

Phone Number' (refer to “Configuring the Endpoint Phone

Numbers” on page 181).

 [1] Cyclic Ascending (default) = Selects the next available

channel in an ascending cyclic order. The next highest

channel number in the Hunt Group is always selected. When

the highest channel number in the Hunt Group is reached,

the lowest channel number in the Hunt Group is selected,

and then it starts ascending again.

 [2] Ascending = Selects the lowest available channel. The

lowest channel number in the Hunt Group is always first

selected, and if that channel is unavailable, the next highest

channel is selected.

 [3] Cyclic Descending = Selects the next available channel

in descending cyclic order. The next lowest channel number

in the Hunt Group is always first selected. When the lowest

channel number in the Hunt Group is reached, it selects the

highest channel number in the Hunt Group and then start

descending again.

 [4] Descending = Selects the highest available channel. The

highest channel number in the Hunt Group is always first

selected, and if that channel is unavailable, the next lowest

channel is selected.

 [5] Dest Number + Cyclic Ascending = The channel is first

selected according to the called number. If the called

number isn't found, the next available channel in ascending

cyclic order is selected. Note that if the called number is

found, but the channel associated with the number is busy,

the call is released.

 [6] By Source Phone Number = Selects the channel

according to the calling number.

Registration Mode

[TrunkGroupSettings_Registrati

onMode]

Registration mode per Hunt Group:

 [1] Per Gateway = Single registration for the entire device

(default). This mode is applicable only if a default Proxy or

Registrar IP are configured, and Registration is enabled (i.e.,

parameter IsRegisterUsed is set to 1). In this mode, the URI

userpart in the From, To, and Contact headers is set to the

value of the global registration parameter

GWRegistrationName (refer to ''Proxy & Registration

Parameters'' on page 112) or use

rname if

GWRegistrationName is not configured.

 [0] Per Endpoint = Each channel in the Hunt Group registers

individually. The registrations are sent to the

ServingIPGroupID if defined in the table, otherwise to the

default Proxy, and if no default Proxy, then to the Registrar

IP.

 [4] Don't Register = No registrations are sent by endpoints

pertaining to the Hunt Group. For example, if the device is

configured globally to register all its endpoints (using the

parameter ChannelSelectMode), you can exclude some

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 389 390

Comentarios a estos manuales

Sin comentarios

AudioCodes MediaPack 114 Manual de usuario Pagina 184

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes MediaPack 114