AudioCodes MediaPack 114 Manual de usuario Pagina 314

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 390
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 313
SIP User's Manual 314 Document #: LTRT-65411
MediaPack Series
An example of a User Information file is shown in the figure below:
Figure 6-1: Example of a User Information File
Note: The last line in the User Information file must end with a carriage return (i.e.,
by pressing the <Enter> key).
The User Information file can be loaded to the device using the ini file (UserInfoFileName
parameter described in ''Auxiliary / Configuration Files Parameters'' on page 303), the
Web
interface (refer to ''Loading Auxiliary Files'' on page 210), o
r by using the automatic update
mechanism (UserInfoFileURL, refer to the Product Reference Manual).
The maximum permissible size of the file is 10,800 bytes.
Each PBX extension registers separately (a REGISTER message is sent for each entry
only if AuthenticationMode is set to Per Endpoint) using the IP number in the From / To
headers. The REGISTER messages are sent gradually. Initially, the device sends requests
according to the maximum number of allowed SIP dialogs (configured by the parameter
NumberOfActiveDialogs). After each received response, the subsequent request is sent.
Therefore, no more than NumberOfActiveDialogs dialogs are active simultaneously. The
user name and password are used for SIP Authentication when required.
The calling number of outgoing Tel-to-IP calls is first translated to an IP number and then (if
defined), the manipulation rules are performed. The Display Name is used in the From
header in addition to the IP number. The called number of incoming IP-to-Tel calls is
translated to a PBX extension only after manipulation rules (if defined) are performed.
Vista de pagina 313
1 2 ... 309 310 311 312 313 314 315 316 317 318 319 ... 389 390

Comentarios a estos manuales

Sin comentarios