AudioCodes MediaPack 114 Manual de usuario descargar pdf (Pagina 246)

SIP User's Manual 246 Document #: LTRT-65411

MediaPack Series

Parameter Description

acBoardCallResourcesAlarm Alarm Trap with a 'major' Alarm Status.

The range is 0 to 100. The default value is 90.

Note: The percentage of busy endpoints is calculated by dividing the

number of busy endpoints by the total number of “enabled” endpoints.

RAILowThreshold

Low threshold percentage of total calls that are active (busy

endpoints).

When the percentage of the device's busy endpoints falls below this

Low Threshold, the device sends an SNMP

acBoardCallResourcesAlarm Alarm Trap with a 'cleared' Alarm Status.

The range is 0 to 100%. The default value is 90%.

RAILoopTime

Time interval (in seconds) that the device periodically checks call

resource availability.

The valid range is 1 to 200. The default is 10.

Disconnect Supervision Parameters

TelConnectCode

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

DisconnectOnBrokenCon

nection

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

BrokenConnectionEventTi

meout

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

EnableSilenceDisconnect

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

FarEndDisconnectSilence

Period

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

FarEndDisconnectSilence

Method

For a description of this parameter, refer to ''Advanced Parameters''

on page 129.

FarEndDisconnectSilence

Threshold

Threshold of the packet count (in percentages) below which is

considered silence by the device.

The valid range is 1 to 100%. The default is 8%.

Note: Applicable only if silence is detected according to packet count

(FarEndDisconnectSilenceMethod = 1).

Automatic Update Parameters

CmpFileURL

Specifies the name of the cmp file and the location of the server (IP

address or FQDN) from which the device loads a new cmp file and

updates itself. The cmp file can be loaded using HTTP, HTTPS, FTP,

FTPS, or NFS.

For example: http://192.168.0.1/filename

Notes:

 When this parameter is set in the ini file, the device always loads

the cmp file after it is reset.

 The cmp file is validated before it's burned to flash. The checksum

of the cmp file is also compared to the previously-burnt checksum

to avoid unnecessary resets.

 The maximum length of the URL address is 255 characters.

IniFileURL

Specifies the name of the ini file and the location of the server (IP

address or FQDN) from which the device loads the ini file. The ini file

can be loaded using: HTTP, HTTPS, FTP, FTPS or NFS.

For example:

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 389 390

Comentarios a estos manuales

Sin comentarios