AudioCodes MediaPack 114 Manual de usuario descargar pdf (Pagina 128)

SIP User's Manual 128 Document #: LTRT-65411

MediaPack Series

Parameter Description

Hook-Flash Option

[HookFlashOption]

Determines the supported hook-flash Transport Type (i.e., method by

which hook-flash is sent and received).

 [0] Not Supported = Hook-Flash indication isn't sent (default).

 [1] INFO = Send proprietary INFO message with Hook-Flash

indication.

 [4] RFC 2833

 [5] INFO (Lucent) = Send proprietary INFO message with Hook-

Flash indication.

Notes:

 The FXO interfaces support the receipt of RFC 2833 Hook-Flash

signals.

 The FXS interfaces send Hook-Flash signals only if EnableHold is

set to 0.

Digit Mapping Rules

[DigitMapping]

Digit map pattern. If the digit string (i.e., dialed number) matches one

of the patterns in the digit map, the device stops collecting digits and

establishes a call with the collected number.

The digit map pattern can contain up to 52 options, each separated by

a vertical bar (|). The maximum length of the entire digit pattern is 152

characters.

Available notations:

 [n-m]: Range of numbers (not letters).

 . (single dot): Repeat digits until next notation (e.g., T).

 x: Any single digit.

 T: Dial timeout (configured by the parameter TimeBetweenDigits).

 S: Immediately applies a specific rule that is part of a general rule.

For example, if your digit map includes a general rule 'x.T' and a

specific rule '11x', for the specific rule to take precedence over the

general rule, append 'S' to the specific rule (i.e., '11xS').

An example of a digit map is shown below:

11xS|00T|[1-7]xxx|8xxxxxxx|#xxxxxxx|*xx|91xxxxxxxxxx|9011x.T

In the example above, the last rule can apply to International numbers

- 9 for dialing tone, 011 Country Code, and then any number of digits

for the local number ('x.').

Dial Tone Duration [sec]

[TimeForDialTone]

Duration (in seconds) that the dial tone is played.

FXS interface plays the dial tone after the phone is picked up (off-

hook); while FXO interface plays the dial tone after port is seized in

response to ringing (from PBX/PSTN). The default time is 16.

Notes:

 During play of dial tone, the device waits for DTMF digits.

 This parameter is not applicable when Automatic Dialing is

enabled.

Hotline Dial Tone Duration

[HotLineToneDuration]

Duration (in seconds) of the Hotline dial tone. If no digits are received

during this duration, the device initiates a call to a user-defined

number (refer to Automatic Dialing on page 175).

The valid ra

nge is 0 to 60. The default is 16.

Note: This parameter is applicable for both FXS and FXO interfaces.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 389 390

Comentarios a estos manuales

Sin comentarios

AudioCodes MediaPack 114 Manual de usuario Pagina 128

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes MediaPack 114