AudioCodes MediaPack 114 Manual de usuario descargar pdf (Pagina 307)

Version 5.6 307 November 2008

SIP User's Manual 6. Auxiliary Configuration Files

6 Auxiliary Configuration Files

This section describes the auxiliary files (with the dat file extension), which are loaded, in

addition to the ini file, to the device. You can load the auxiliary files to the device using one

of the following methods:

 Web interface (refer to ''Loading Auxiliary Files'' on page 210)

 ini file: specif

y the name of the relevant auxiliary file in the device's ini file and then

load the ini file to the device (refer to ''Loading Auxiliary Files'' on page 210).

6.1 Configuring the Call Progress Tones File

The Call Progress Tones (CPT) and Distinctive Ringing auxiliary file used by the device is a

binary file (with file extension dat). This file is comprised of two sections. The first section

contains the definitions of the Call Progress Tones (levels and frequencies) that are

detected / generated by the device. The second section contains the characteristics of the

distinctive ringing signals that are generated by the device (refer to Configuring the

Distinctive Ringing Section of the ini File on page 310).

You ca

n either use one of the supplied device auxiliary (dat) files or create your own file. To

create your own auxiliary file, it's recommended to modify the supplied usa_tone.ini file (in

any standard text editor) to suit your specific requirements, and to convert the modified ini

file into binary format using the TrunkPack Downloadable Conversion Utility. For the

description of the procedure on how to convert CPT ini file into a binary dat file, refer to the

Product Reference Manual.

To load the Call Progress Tones (dat) file to the device, use the Web interface or ini file

(refer to ''Loading Auxiliary Files'' on page 210).

Note: Only the dat file can be loaded to the device.

You can create up to 32 different Call Progress Tones, each with frequency and format

attributes. The frequency attribute can be single or dual-frequency (in the range of 300 to

1980 Hz), or an Amplitude Modulated (AM). In total, up to 64 different frequencies are

supported. Only eight AM tones, in the range of 1 to 128 kHz, can be configured (the

detection range is limited to 1 to 50 kHz). Note that when a tone is composed of a single

frequency, the second frequency field must be set to zero.

The format attribute can be one of the following:

 Continuous: (e.g., dial tone) a steady non-interrupted sound. Only the 'First Signal On

time' should be specified. All other on and off periods must be set to zero. In this case,

the parameter specifies the detection period. For example, if it equals 300, the tone is

detected after 3 seconds (300 x 10 msec). The minimum detection time is 100 msec.

 Cadence: A repeating sequence of on and off sounds. Up to four different sets of on /

off periods can be specified.

 Burst: A single sound followed by silence. Only the 'First Signal On time' and 'First

Signal Off time' should be specified. All other on and off periods must be set to zero.

The burst tone is detected after the off time is completed.

1 2 ... 302 303 304 305 306 307 308 309 310 311 312 ... 389 390

Comentarios a estos manuales

Sin comentarios

AudioCodes MediaPack 114 Manual de usuario Pagina 307

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores AudioCodes MediaPack 114